With the rapid progress of electronic and information technology, an expectation for the realization of body area network (BAN) has risen. However, on-body transmission characteristics are greatly dependent on the frequency, and a high-speed transmission is difficult due to the remarkable signal attenuation at higher frequencies. In this study, we proposed a pulse transmission system with the frequencies at dozens of mega-hertzes. The system was based on an impulse radio (IR) scheme with bi-phase modulation. By using the frequency-dependent finite difference time domain (FD2TD) method, we investigated the on-body transmission characteristics and derived a path loss expression. Based on the transmission characteristics, we also investigated the influences of white Gaussian noises and other narrow-band interferences on the communication link budget and bit error rate (BER) performance. The results have shown the feasibility of the proposed on-body IR communication system.

MIMO systems using a space division multiplexing (SDM) technique in which each transmit antenna sends an independent signal substream have been studied as one of the successful applications to increase data rates in wireless communications. The throughput of a MIMO channel can be maximized by using an eigenbeam-SDM (E-SDM) technique, and this paper investigates the practical performance of 22 and 44 MIMO E-SDM based on indoor measurements. The channel capacity and bit error rate obtained in various uniform linear array configurations are evaluated and are compared with the corresponding values for conventional SDM. Analysis results show that the bit error rate performance of E-SDM is better than that of SDM and that E-SDM gives better performance in line-of-sight (LOS) conditions than in non-LOS ones. They also show that the performance of E-SDM in LOS conditions depends very much on the array configuration.

This paper investigates the impact of chip duty factor (DF) in DS-UWB system with Rake receiver over AWGN and UWB indoor multipath environment corresponding to system parameters such as spreading bandwidth and chip length. Manipulating DF in DS-UWB system offers several advantages over multipath channel and thus, capable of improving system performance for better quality of communication. Although employing lower DF generally improves performance, in some exceptional cases on the other hand, degradation can be observed despite decreasing DF. Therefore, the objective of this paper is to clarify the relationship between DF and DS-UWB system performance. We discovered that with constant processing gain and spreading bandwidth, performance improvement can be observed at DF lower than 0.17. Additionally, with spreading bandwidth as tradeoff parameter, significant performance improvement can only be observed below DF of 0.85.

This letter proposed a linear precoding scheme for the V-BLAST system that requires only knowledge of the statistical CSI; the transmitter does not need the instantaneous CSI. Power allocation on the eigenmodes of the transmit correlation matrix is one way to minimize bit error rate (BER). Simulation results show that the proposed precoding V-BLAST system provides a significant reduction in the BER compared with the conventional V-BLAST systems.

Some signal design methods for the approximately synchronized CDMA systems based on complete complementary codes have been proposed. It has been shown that estimating the multipath channels and applying the convolution of the spread signals can increase both the information transmission rate and frequency usage efficiency. There are some variations of such signal design methods using complete complementary codes. The efficiency of the communication systems and information transmission rate depend upon the applied signal design method and the modulation scheme. In this paper, we consider two of these signal design methods. We analyze the bit error rate (BER) performances for both methods through some numerical simulations under the single cell scenario. Numerical results show the BER properties under some modulation schemes such as BPSK, QPSK and 16QAM. Some discussions on the relation between the BER performance and the information transmission rate are also included.

This paper presents a closed form expression of an exact average bit error rate (BER) for a time-division duplex (TDD) transmit diversity scheme employing maximal ratio combining (MRC) over time selective flat Rayleigh fading channels. In the proposed analysis, the feed back delay which degrades the BER performance is taken into account. The results are generally applicable to an arbitrary modulation scheme, as well as an arbitrary number of transmitting branches. To confirm the validity of the proposed analysis, the theoretical results are compared with the simulated ones.

In orthogonal frequency division multiplexing (OFDM) systems with differential phase shift keying (DPSK), it is possible to apply differential modulation either in the time or frequency domain depending on the condition of fading channels, such as the Doppler frequency shift and the delay spread. This paper proposes a simple calculation method, that is, an approximate closed-form equation of the bit error rate (BER) in DPSK/OFDM systems mentioned above over both time and frequency selective Rician fading channels. The validity of the proposed method is demonstrated by the fact that the BER performances given by the derived equation coincide with those by Monte Carlo simulation.

In this paper, the bit error rate (BER) and the outage probability are presented for a maximal ratio combining (MRC) two-dimensional (2D)-RAKE receiver operating in a correlated frequency-selective Nakagami-m fading environment with multiple access interference. A simple approximated probability distribution function of the signal-to-interference-plus-noise ratio (SINR) is derived for the receiver with multiple correlated antennas and RAKE branches in arbitrary fading environments. The combined effects of spatial and temporal diversity order, average received signal-to-noise ratio, the number of multiple access interference, angular spread, antennae spacing and multi-path Nakagami-m fading environment on the system performance are illustrated. Numerical results indicate that the performance of the 2D-RAKE receiver depends highly on the operating environment and antenna array configuration. The performance can be improved by increasing the spatio-temporal diversity gains and antenna spacing.

Analytical derivation of bit error rates for multi-user coherent chaos-shift-keying (CSK) communication systems are presented in this paper. Nearly exact results are obtained by applying the central limit theorem of statistics to sums of independent variables. Based on χ2 distribution approximations, more viable but still very accurate results decrease complexity of the calculations. The χ2 approach is compared with the widely used Gaussian approximation approach to show its superiority in most cases. Bit error performance bounds for the multi-user CSK system from the approach are deduced as further contributions of this paper. The theoretical results obtained are entirely consistent with a range of simulations.

In this paper, we derive expressions for the bit error probability of QPSK/OFDM on frequency-selective Rayleigh fading channels. In the OFDM system, ICI (interchannel interference) caused by Doppler spread of the channel degrades the error performance of the system and introduces the error floor even for coherent detection. Analysis results show that the error performance of QPSK/OFDM can be degraded as the normalized maximum Doppler frequency fD /Bsub is increased where fD is the maximum Doppler frequency and Bsub is the subchannel bandwidth. Computer simulations confirm the theoretical analysis results for BPSK and QPSK signals.

Bit error rate estimation of the LEO satellite channel is presented. Since it could hardly be expressed the bit error rate under the practical degradation factors in a closed form, the method to predict the bit error rate using the known moments of the degradation factors is employed. The numerical example in this analysis is provided, especially, under the effects of Traveling Wave Tube Amplifier (TWTA) nonlinearity, fading effect and intersymbol interference (ISI). Under Ricean fading channel model, in the LEO environment, the result shows the system performance is worse and couldn't be used for voice communication when the LEO satellite is located at a lower elevation angle (EL). Besides, the degradation of the effect of ISI is more prominent when the LEO satellite is located at a higher EL.

The bit error rate (BER) for an uplink multicell multicarrier code-division multiple-access (MC-CDMA) system in Nakagami-m fading channels is derived and expressed in the form of a single integral. The result is obtained without the approximation for the ratio of the interference power from other-cell to the power from the user-of-interest. Numerical results demonstrate the impacts of other-cell interference and power control errors on the BER.

The transmission quality in mobile wireless communication systems is affected by not only AWGN but also multi-path fading. Particularly, the Doppler frequency, the delay spread and the Rician factor have a great influence upon the quality over fading channels. This letter proposes the approximate equation for easily calculating the BER in DS-CDMA systems over multi-path fading channels. The validity of the approximate equation is confirmed from the fact that the BER calculated by the equation coincides with that by the computer simulation.

Adaptive optimization of the notch bandwidth of a lattice-based adaptive infinite impulse response (IIR) notch filter is presented in this paper. The filter is used to improve the performance of a direct sequence spread spectrum (DSSS) binary phase shift keying (BPSK) communication system by suppressing a narrow-band interference at the receiver. A least mean square (LMS) algorithm used to adapt the notch bandwidth coefficient to its optimum value which corresponds to the maximum signal to noise ratio (SNR) improvement factor is derived. Bit error rate (BER) improvement gained by the DSSS communication system using the filter with the optimized notch bandwidth is also shown. Computer simulation results are compared with those obtained analytically to demonstrate the validity of theoretical predictions for various received signal parameters.

We propose a subchannel power control scheme in the OFDM system, which transmits data with a variable power level for each subchannel based on the received SNR. The OFDM system, employing the D-QPSK modulation and the proposed subchannel power control with a grouping coefficient equal to 3, gives about 2.3 dB gain in Eb/N0 comparing with the conventional OFDM system, under the two-ray multipath channel with the mean value of the second-ray's attenuation coefficient equal to 0.25, for the required BER equal to 10-5.

Transmitter diversity is a powerful technique to improve the transmission quality of downlink in microcellular mobile communications systems. Under cochannel interference (CCI) at the base station (BS), the transmitter diversity is not necessarily effective, because the desired-plus-interference signal power used as a criterion of downlink branch selection is not always relative to the downlink propagation condition. This paper proposes the theoretical derivation of bit error rate (BER) performance in the transmitter diversity under CCI occurring at BS, as parameters of average SIR at BS, normalized Doppler frequency, and so on. It is confirmed from the correspondence of theoretical results with simulation results that the proposed theoretical approach is applicable to the CCI environments at BS.

New method for deriving the bit error rate (BER) of the BPSK signal in the cochannel interference is proposed, which utilizes the eye pattern of the interference signal, and is different from the conventional method based on the conversion of the interference components to thermal noise. The validity of the proposed derivation method is quantitatively evaluated in terms of the BER performance and is confirmed by comparing with the results obtained by the computer simulation.

We evaluate the BER performance of the OFDM system with the one-tap equalizer bank under the two-ray multipath channel with the frequency offset by the simple Gaussian analysis method and by a proposed modified Gaussian analysis method. The proposed analysis method considers two adjacent inter-channel interferences, separately, and models the other inter-channel interferences as a Gaussian noise. It is shown that the proposed analysis method affords much closer results to the simulations than those by the simple Gaussian analysis method, when the frequency offset exists.

We have developed a measuring system for high-Tc superconducting single-flux quantum circuits and evaluated its performance in terms of bit error rate (BER) measurement for given signal voltage levels. The system includes magnetic shields and a high-frequency test fixture mounted on a closed-cycle cooler. The test fixture is made of non-magnetic material. The transmission characteristics of the measuring system were evaluated by using a vector network analyzer at frequencies ranging from 40 MHz to 20 GHz. The operating temperature of the measuring system ranges from 20 K to room temperature. We connected a 12-GHz wideband pulse amplifier to the system and evaluated its high-speed transmission characteristics. We used a standard 50-Ω microstrip line as an impedance-matched sample. The signal used in the experiment was a 215-1 pseudo random bit signal (PRBS) at 3 Gbps. As a result, the output voltage required for an output driver under the experimental condition was 18.8 mV in order to obtain a resolution of BER measurement of 10-12.

The transmission quality in mobile wireless communications is affected by not only the thermal noise but also the multipass fading which changes drastically an amplitude and a phase of received signal. The paper proposes the theoretical and approximate methods for deriving an average bit error rate in DS-CDMA systems under the Rician fading environment on the assumption of the frequency non-selective fading, as parameters of the number of simultaneous access stations, the maximum Doppler frequency and so on. It is confirmed from the coincidence of theoretical and approximate results with simulation ones that the proposed approach is applicable to a variety of system parameters.